Otter-outdoors Pro Ice Lodge Manuel d'utilisateur

Page 1Otter Pro Ice LodgeInstallation and Set-Up InstructionsOtter Pro Ice LodgeFits Magnum Otter II & Pro Sled OnlyParts Identification and Check

Page 1019. Slide the tent over the main frame barassembly, then fasten the velcro strapson the inside of the tent to each mainframe bar. Ref. Diagram

Page 1121. On the front of the fishhouse, start in the corners and work inward, snap the plastic trim seal on the canvas tent(Item 2) to the top edge

Page 12Otter Pro Ice LodgeOctober, 2011Otter Outdoors Inc.411 W Congress St. • Maple Lake, MN 55358Phone 320-963-6480 • www.otteroutdoors.comHOLE DRI

Page 22. Place the seat rail bracket (Item 20) on the first hole and mark second hole location. Note: Bracket for front ofsled has a different bend th

Page 33. Attach seat rail (Item 18) to seat rail bracket (Item 20) and secure with bolt (Item 29) and nut (Item 30), bothends. Attach seat rail cap (I

Page 46. Slide the seat assembly (assembled in step 4) onto the seat base (Item 17). Check the fit on the plastic seat base(Item 17) and adjust the me

Page 57. Position sled (Item 1) as shownin Diagram 7, with curved frontto your left. Using front drillingpattern (on back page) marktwo holes for the

Page 612. Attach Back and Center main frame assemblies (Assembled in Step 11) onto frame brackets (Item 3 and 4).Secure with 1/4 nylon hex lock nut (I

Page 714. Attach Front main frame assembly (Assembled in Step 13) onto frame brackets (Item 3 and 4). Secure with 1/4nylon hex lock nut (Item 28). Ref

Page 816. Attach Bottom main frame assembly (Assembled in Step 15) onto frame brackets (Item 3 and 4). Secure with 1/4 nylon hex lock nut (Item 28). R

Page 918. Install wind support bars starting in back (Item 5), up through center (Item 6), then between the front and centermain frame bars (Item 7) a